Antenna with cosecant squared pattern are special designed for air- surveillance radar sets. These permit an adapted distribution of the radiation in the beam. a fan beam. Figure Vertical projection of the radiation pattern of an antenna with cosecant squared characteristic, the blue graph shows the theoretically form, . This paper deals with the analysis and proper design of parabolic reflector antennas to obtain pencil beam, cosecant-squared and inverse cosecant- squared.
|Published (Last):||26 March 2017|
|PDF File Size:||5.66 Mb|
|ePub File Size:||20.47 Mb|
|Price:||Free* [*Free Regsitration Required]|
Vertical projection of the radiation pattern of an antenna with cosecant squared characteristic. Antennae with constant height pattern or cosecant squared pattern are special designed for air-surveillance radar sets.
These permit an adapted distribution of the radiation in the beam and causing a more ideal space scanning. This antenna pattern can get the required elevation coverage where the received power is independent of the radar range for a constant height target It is a cosecznt of achieving a more uniform signal strength at the input of the receiver as a target moves with a constant height within the beam.
In the practice a cosecant squared pattern can be achieved by a deformation of a parabolic reflector. A radiator is in the focal point of a parabolic reflector and produces a relatively sharply bundled radiation lobe since the rays leave the reflector parallelly in the ideal case.
Cosecant squared antenna
To get the cosecant squared pattern, a part of the radiated energy must be turned up. A possibility consists in lower bending of the top of the reflector. The part coseccant the rays which falls to the less bent area in the top is reflected up now.
A possible method analogously for this one is, to bend the lower coeecant of the reflector more intense. The lobe of the radiator is weaker to the margin to, therefore the margins of the reflector are hit weaker as the centre.
By the fact that the rays turned up don’t have a large power density, the maximum range in the higher elevation is limited with that.
The ideal pattern as shown in Figure 1 is a nearly rectangular shape with rounded corners. Squaree reality, the diagram is superposed with a number of side lobes mainly on the back square higher elevation angles. The shape of all these back side lobes is combined into a nearly parabolic slope.
Cosecant squared antenna – Wikipedia
This gives antnna near range an additional gain required for constant echo strength after sensitivity time control. Cosecant-squared pattern achieved by displacing the reflector surface from the original parabolic shape.
Every feed horn already emits directionally. If one distributes the transmit power unevenly on the single radiating elements, then the antenna pattern approaches a cosecant squared pattern. At use of several receiving channels a height allocation also can be carried out.
The targets can be assigned to beams with defined elevation there. The cosecant squared pattern isn’t restricted to parabolic reflectors. This can be realized also with other kind of antennae. At an antenna array with Yagi- antennae the pattern is achieved by interference of the direct wave with this at the earth’s coscant reflected quotas.
It is equal to the reciprocal value of the sine function. However, what does this term have to do with our antenna? If the echo has a uniform signal strength at the input of the receiver than the range squarsd dependent on the square of the antenna gain in the fourth power linearly. According to definition mentioned above the height also shall be constant. That means, we can antsnna the height too without changing the dependence.
Antenna with Cosecant Squared Pattern Cosecant squared pattern. Stacked beam cosecant squared pattern.