F – 80 Standard Test Methods for Fluid Resistance Of Gasket Materials. Designation: F – Standard Test Methods for. Fluid Resistance of Gasket Materials1 This standard is issued under the fixed designation F ; the. ASTM F – 04 Fluid Resistance of Gasket Materials This standard is issued under the fixed designation F ; the number immediately following the.
|Published (Last):||3 May 2010|
|PDF File Size:||20.34 Mb|
|ePub File Size:||13.94 Mb|
|Price:||Free* [*Free Regsitration Required]|
Current edition approved April 1, ICS Number Code Refer to Test Method D for further information regarding immersion test fluids.
ASTM F – 01 Standard Test Methods for Fluid Resistance of Gasket Materials
It is designed for testing specimens cut from gasketing materials or from finished articles of commerce. The specific test fluids and test conditions outlined asmt selected as typical for purposes of comparing different materials and can be used as a routine test when agreed upon between the purchaser and the manufacturer.
These test methods are not applicable to the testing of vulcanized rubber, a procedure that is described in Test Method D A number in parentheses indicates the year of last reapproval. It is designed for testing specimens cut from gasketing awtm or from finished articles of commerce.
Summary of Test Methods 3. Pour enough fresh test fluid over the specimens to ensure that the specimens are wetted and covered by the fluid.
There were six Type 1,7, three Type 3, and one Type 5 material evaluated for immersion weight change and thickness change ashm IRM oil. Historical Version s – view previous versions of standard.
F — 04 Standard Test Methods for Fluid Resistance of Gasket Materials1 This standard is issued under the fixed designation F ; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of awtm revision. The inch-pound units in parentheses are for information only. Change the distilled water used in the test frequently.
If such information is not available, then the material should be tested by itself in fresh fluid to determine compatibility with said g146. For materials having less than specific gravity 1.
The results of these test methods are not intended astj give any direct correlation with service conditions in view of the wide variations in temperature and special uses encountered in gasket applications.
Insert the aluminum-foil covered stoppers into the test tubes before placing them in the supporting rack within the oven. The anvil shall have a diameter not less than that of the presser foot, which has a diameter of 6.
Last previous edition approved in as F — Other physical property tests described in this standard are not applicable for these materials. Precision and Bias 7 These test methods are not applicable to the testing of vulcanized rubber, a procedure that is described in Test Method D Exercise care when removing the excess fluid so that no squeezing action occurs on the sample. Measure the weight of the test specimen to the nearest 1 mg 0. Type 1 Class 2—A BA material, containing a normally lower swelling polymer.
ASTM F 146 – 04
Link to Active This link will always route to the current Active version of the standard. Users of this standard are expressly advised that determination of the validity of any such asttm rights, and the risk of infringement of such rights, are entirely their own responsibility.
ASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard. Thank you for interesting in our services. We need your help! It is asm responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. We are a non-profit group that run this website to share documents.
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. A superscript epsilon e indicates an editorial change since the last revision or reapproval.